| Digital Regulator Control for General Electric, Siemens,
Cooper and Howard Regulators.
Features
- Conventional and Autodaptive® (Phase II) Control
Methods
- Adjustable Bandcenter
- Adjustable Bandwidth
- Line Drop Compensation, R, X and Z Compensation
- Time Delay, Definite and Inverse
- InterTap Time Delay
- Selectable Outputs, Continuous or Pulsed
- Reverse Power Operation for Single-Phase
- Regulator applications
- CT to VT Phasing Correction
- Real-Time Metering of measured and calculated parameters
- Demand Metering with selectable time interval
- Drag Hands Operation
- Adjustable Line Overcurrent Tapchange
Inhibit
- Voltage Limits
- Tap Position Limits
- Auto Runback
- Three independent Voltage Reduction Steps
- Sequential and Non-Sequential Operation
- VT Ratio Correction
- Tap Position Knowledge by "Keep Track"
method
- Operations Counter
- Resettable Operations Counter
- Harmonic Analysis (Phase II)
- Tap Position Record
- Auto/Off/Manual Switch Status
- A or B Regulator Type Selection
- User Programmable Alarm Contact
- SCAMP™ (SCADA Controllable Auto/
Manual Pushbutton)
- SCADA Cutout (Local/Remote) switch
allows blocking of SCADA Commands
- Control Voltage Input
- Motor Power Input
- Line Current Input
- Raise Output
- Lower Output
- 20 Character by 2 Row LED backlit LCD
Display
- M-2029B TapTalk® Communications
Software
- M-2829 TapPlot™ Tap Analysis Software
- USB Communications Port (12 Mbps)
- VAr Bias
- SD Card
- SOE Sequence of Events
- Data Logging
- Oscillography (Phase II)
- External Inhibit of Auto Tapchange
- Front Panel LEDs for Out-of-Band Raise,
Out-of-Band Lower, Reverse Power Flow
Rev Pwr Detected, CPU OK, MANUAL,
LOCAL, Voltage reduction V/RED in Effect,
LDC in Effect Voltage Reduction 1 & 2 Inputs (Binary)
- Neutral Position Detect (Binary)
- Counter Input (Binary)
- Seal-in/Switch Status Input (Binary)
- Non-Sequential/SCADA Block Input (Binary)
- COM1, RS-485 or Fiber Optics
- Communication Protocols include DNP3.0,
2179 (Phase II) and MODBUS
Optional Features
- Ethernet Port (Phase II) (10/100 Mpbs) is
available through an RJ-45 jack. This port
supports DNP over TCP/IP, MODBUS over
TCP/IP, and IEC-61850 over TCP/IP
- RS-232 Communications Port (Phase II)
- Control Power Back-Up Input – input (+12 V
dc) for backup of Fiber Optic loop-through
communication
- Local Wireless Bluetooth capability
(Phase II)
Accessories
- M-2026 AC-DC Control Power Backup
Supply
- M-2027 Control Power Backup Supply–AC
Only
Sales and Service
For sales and service information
contact your local representative
or contact the factory:
E-mail: sales@beckwithelectric.com
Call (727) 544-2326
or Fax (727) 546-0121
|
 |
En Español (Pulsar aquí)
 |
Note: Documents are provided in Adobe
Acrobat PDF format and require Acrobat
5.0 or higher to view.
|
|
